I completed a installation inspection on a five star 80% gas furnace I completed installation checklist cycled and monitored the system operating normally at this time
I Installed shark byte and water line for humidifier. I Tested the humidifier operation and water lines for leaks. Everything working. Properly at this time.
Inspection in progress.....will return to complete.
Upon arrival I replaced the filter rack and set gas pressures. The system is operational upon departure.
Upon arrival I de-installed in order to replace the drain pan that is blocking the door with a smaller drain pan. The system is operational upon departure.
Upon arrival I installed the FLUE TERMINATION FLARE GAS LINE, take 3” PVC material to finish flu and intake. The system is operational upon delivery.
Upon arrival I installed 3" PVC and finished the flue and intake. The system is operational upon departure.
Upon arrival I installed their PVC flue. The system is operational upon departure.
After arriving to the clients house we were unable to lift the furnace to pull the old pan out and upon further review of the installation some rework is going to have to be done. We are going to reschedule for earlier in the morning due to it being an attic. This will be a deinstall reinstall.
Arrived at jobsite and installed a carrier filter rack. The system is operational upon departure.
I completed a Full Install of a Carrier 80% Gas Furnace 58SBO (Up to 100,000 BTU) Honeywell T6 Programmable Thermostat/Emerson 1F85U Carrier 13 SEER Air Conditioner 24ABB3 (Up to 3 ton). The system is operational upon departure.
I arrived on site to re-install trim for the attic of the customer with the Concord Heat Pump.
I completed scheduled maintenance spring tune up on a Bryant air conditioner. I visually inspected the furnace. Checked voltage and amps. I inspected the evaporator coil. I checked the temperature difference across the coil. Checked refrigerant charge, voltages and amps. I rinsed the condenser coils with water. Cycled and monitored the system. Operating normally at this time.
I completed an installation inspection on a Carrier Multi-Speed X-13 2.5 Ton Electric Furnace / "Slant" Coil and Carrier 15 SEER 2.5 Ton Heat Pump. Completed installation checklist. Cycled and monitored the system. Operating normally at this time.
